User`s guide
6
>> www.celestron.com
The Eyepiece
Ƥ
ǤƤ
star diagonal. To install the eyepiece:
1. Loosen the thumbscrew on the star diagonal so it does not obstruct
the inner diameter of the eyepiece end of the diagonal.
2. Slide the chrome portion of the eyepiece into the star diagonal.
3. Tighten the thumbscrew to hold the eyepiece in place.
To remove the eyepiece, loosen the thumbscrew on the star diagonal
and slide the eyepiece out.
Eyepieces are commonly referred to by focal length and barrel diameter.
The focal length of each eyepiece is printed on the eyepiece barrel.
The longer the focal length (i.e., the larger the number) the lower the
ƤǢ
ȋǤǤǡȌƤǤǡ
ǦǦǤ
ǡDzƤǤdz
Barrel diameter is the diameter of the barrel that slides into the star
diagonal or visual back. The CPC uses eyepieces with a standard 1-1/4”
barrel diameter.
ĎĘĚĆđĆĈĈĊĘĘĔėĎĊĘċĔėęčĊ͡Ǥ͚͝Ȁ͙͙dz
͛ǧ͝
͚dz
͚dz
The Finderscope
͘͡͝ƤǤƤ
ƤƤǡ
ǡǤǡ͘͡͝ƤƤ
͘͝Ǥ
Finderscope Installation
ƤƤǦ
bracket then attached to the rear cell of the telescope. To install
Ƥǣ
͙Ǥ Ƥ
ƤǤ
ƤǤ
͚Ǥ ǡ
when looking from the back of the tube.
3. Place the mounting bracket over the two holes of the rear cell as
Ƥ͛Ǧ͟Ǥ
͜Ǥ Ǥ
WARNING: If you remove the mounting bracket, do not
completely thread the screws back into the rear cell of the
telescope. The screws may be long enough to obstruct the
movement of, and possibly damage the primary mirror.
čĊċĎēĉĊėĘĈĔĕĊćėĆĈĐĊęĈĔĒĊĘĎēęĜĔ
ĕĎĊĈĊĘǢęčĊĒĔĚēęĎēČćėĆĈĐĊęȋęĔĕȌĆēĉęčĊ
ċĎēĉĊėćėĆĈĐĊęȋćĔęęĔĒȌ
͛ǧ͟
Ƥǡ
ƤǤ
͙Ǥ ǦƤ
ƤǤ
͚Ǥ Ƥ
ȋȌǡ
Ǥ
Ƥ
ȋƤ͛Ǧ͞ȌǤ
͛Ǥ ƤǦ
ƤǤ
͜Ǥ
ƤǤ
͛ǧ͠
͛ǧ͞