Instructions / Assembly

6 I ENGLISH
Set up your Travel Scope indoors the first time and familiarize yourself with the correct assembly procedure before
attempting it outdoors.
ASSEMBLY
SETTING UP THE TRIPOD
1. The tripod comes preassembled. Stand the tripod upright and
pull the tripod legs outward until each leg is fully extended.
2. To raise the height of the tripod, unlock the tripod leg lock
clamps at the bottom of each tripod leg by opening the clamp
for each section and pulling outward. Once a clamp is unlocked,
pull the tripod leg out as far as it will go, and then close the
leg lock to secure it. Continue doing this for each tripod leg
and each section to raise the height to the level you desire.
3.
If you want to raise the tripod height up further, use the central
column locking knob. Turn the locking knob counterclockwise
until loose. Then, pull up on the head of the tripod. Continue
pulling to the height you desire and then tighten the locking
knob. To ensure the stability of the mount, make sure the column
extension knob is tight.