User's Manual
Table Of Contents
- CONTENTS
- FIGURES
- TABLES
- INTRODUCTION
- INSTALLATION GUIDE
- Applicable Documents
- Scope
- Important Safety Precautions
- ICU Operation Instructions
- Array Installation
- Assembly Instructions for the PCS 1x4x4 Array
- PCS 1x8x8 Array Assembly Instructions
- BEAMER® System Setup
- BEAMER® System Sector Array Installation Record
- Test Procedure for Measuring the Rx Gain Balance
- Smart-Terminal Program Description
- BSM (BEAMER® SYSTEM MANAGER) PROGRAM
- Functions
- Requirements for Operation
- User Interface Description
- Status Reports
- BSM S/W
- BSM Main Screen
- Comm Port Selection
- Password Entering
- Host Selection
- Installation of ICU in System
- Failure Conditions Selection
- BEAMER® Limits Definition
- Shut Down Conditions Enable/Disable
- ICU Limits Definition
- System Definition
- Sub-Array and BEAMER® Setting
- Sub Array Setting
- BEAMER® Installation
- Column and Row Definition
- Sub-Array Status and Attenuator Setting
- Control & BEAMER® Setting
- BEAMER® Control
- ICU Status
- ICU CTRLR Status
- ICU Properties
- SOFTWARE DOWNLOAD GUIDE
- WARRANTY
- Exclusions
- Warranty Limitations
- INDEX
INSTALLATION GUIDE
Confidential, Proprietary Information
Title: PolBEAMER PCS (3.2) Array System-
Assembly and Operation Manual
Doc. No.:
913000801
Rev.: 01
Page: 56 of 91
Figure 25: Entering and editing a command
2.11.3.1. Editing a Command
To edit a command, enter a value at the Sent Data Input window, followed by Send. If you make a
mistake or wish to correct an existing entry, use the Key Back to clear the entry, byte by byte, until
you have reached the wanted result.
Note that every time Send is pressed, the data at the Sent Data window will be sent to the ICU. This
does not affect the ICU performance - some of the incomplete commands will be ignored, some will
be executed - however, the last complete command will do the required job.
2.11.3.2. Entering a Script Command
When pressing the Get File menu, the programs look for *.bcd files at ./Commands directory. These
files should be stored line by line, in Hex format. The program will display the available scripts at the
Commands directory. Select the script name you wish to send, than press OK.