User's Manual
Table Of Contents
- CONTENTS
- FIGURES
- TABLES
- INTRODUCTION
- INSTALLATION GUIDE
- Applicable Documents
- Scope
- Important Safety Precautions
- ICU Operation Instructions
- Array Installation
- Assembly Instructions for the PCS 1x4x4 Array
- PCS 1x8x8 Array Assembly Instructions
- BEAMER® System Setup
- BEAMER® System Sector Array Installation Record
- Test Procedure for Measuring the Rx Gain Balance
- Smart-Terminal Program Description
- BSM (BEAMER® SYSTEM MANAGER) PROGRAM
- Functions
- Requirements for Operation
- User Interface Description
- Status Reports
- BSM S/W
- BSM Main Screen
- Comm Port Selection
- Password Entering
- Host Selection
- Installation of ICU in System
- Failure Conditions Selection
- BEAMER® Limits Definition
- Shut Down Conditions Enable/Disable
- ICU Limits Definition
- System Definition
- Sub-Array and BEAMER® Setting
- Sub Array Setting
- BEAMER® Installation
- Column and Row Definition
- Sub-Array Status and Attenuator Setting
- Control & BEAMER® Setting
- BEAMER® Control
- ICU Status
- ICU CTRLR Status
- ICU Properties
- SOFTWARE DOWNLOAD GUIDE
- WARRANTY
- Exclusions
- Warranty Limitations
- INDEX
SOFTWARE DOWNLOAD GUIDE
Confidential, Proprietary Information
Title: PolBEAMER PCS (3.2) Array System-
Assembly and Operation Manual
Doc. No.:
913000801
Rev.: 01
Page: 80 of 91
4.4.6. Setting Menu
Setting menu includes the following functions:
• ICU Setting
• Software loading code
• Software remote loader
• Site name
• Destination
• ComPort
4.4.6.1. ICU Setting
If the connected ICU is not configured- meaning that it does not have an address - this function
enables defining and saving an address to the ICU. Click on ICU setting to display the following
window:
Setting ICU’s address is enabled by entering it’s ID number (which is known and is the ICU serial
number).
4.4.6.2. Software Loading Code
This function enables saving to the BEAMER® details about present loading. Software loading code
is an alphanumeric expression up to 20 characters.
4.4.6.3. Software Remote Loader
This function enables saving of the program loader name into the BEAMER® . Software remote
loader is an alphanumeric expression up to 20 characters.