User's Manual
Table Of Contents
- CONTENTS
- FIGURES
- TABLES
- INTRODUCTION
- INSTALLATION GUIDE
- Applicable Documents
- Scope
- Important Safety Precautions
- ICU Operation Instructions
- Array Installation
- Assembly Instructions for the PCS 1x4x4 Array
- PCS 1x8x8 Array Assembly Instructions
- BEAMER® System Setup
- BEAMER® System Sector Array Installation Record
- Test Procedure for Measuring the Rx Gain Balance
- Smart-Terminal Program Description
- BSM (BEAMER® SYSTEM MANAGER) PROGRAM
- Functions
- Requirements for Operation
- User Interface Description
- Status Reports
- BSM S/W
- BSM Main Screen
- Comm Port Selection
- Password Entering
- Host Selection
- Installation of ICU in System
- Failure Conditions Selection
- BEAMER® Limits Definition
- Shut Down Conditions Enable/Disable
- ICU Limits Definition
- System Definition
- Sub-Array and BEAMER® Setting
- Sub Array Setting
- BEAMER® Installation
- Column and Row Definition
- Sub-Array Status and Attenuator Setting
- Control & BEAMER® Setting
- BEAMER® Control
- ICU Status
- ICU CTRLR Status
- ICU Properties
- SOFTWARE DOWNLOAD GUIDE
- WARRANTY
- Exclusions
- Warranty Limitations
- INDEX
SOFTWARE DOWNLOAD GUIDE
Confidential, Proprietary Information
Title: PolBEAMER PCS (3.2) Array System-
Assembly and Operation Manual
Doc. No.:
913000801
Rev.: 01
Page: 82 of 91
4.4.7.1. Enter Password
Clicking on the Enter password function will display the following window:
The displayed window enables entering the required password, which enables the loading process.
4.4.7.2. Low Level
Clicking on Low Level sets the Guest level authorization.
4.4.7.3. Change Password
This function is enabled when the Administrator authorization is enabled and enables changing the
password for authorization.
4.5. Program Loading Procedure
4.5.1. Procedure for Loading Program to the ICU
To load a new version of application program file to the ICU controller, follow the following
instructions:
1. Connect the PC that includes the Celletra program loader program to the ICU via the serial
port.
2. If you wish to keep the log file then save it, otherwise the log file will be erased during the new
file loading.
3. Operate Celletra program loader program and wait until the address of the ICU appears at the
ICU address bar. If the system includes few ICUs, select the address of the required ICU from
the address bar.
4. From the Setting menu select Comport and select the required communication path to the ICU.
• If the PC is connected via the serial port of the PC then check the RS-232 and define the COMM
port in the PC that is used.
• If the PC is connected via the a telephone line by a modem, then check the MODEM and dial the
telephone number of the destination modem.
5. From the Setting menu, click on Destination and select ICU as the destination for loading. The
following warning message will appear to warn that the log file will be erased: