User Manual

Confidential, Proprietary Information

Title: PCS FlexBeamer

RF Repeater

System A &O Manual

Doc. No.:

913002500

Rev.: 00

Page: 12 of

80NUMPAGES

1. PCS BEAMER

FLEXBEAMER® RF

REPEATER SYSTEM DESCRIPTION

This document is a guide to the Installation, operation and maintenance of the PCS RF

FLEXBEAMER® System. This first chapter brings a brief description of the RF Repeater System

overview . PCS RF Channel Selective Repeater System consists of these Three parts:

• BAU (Beamer Antenna Unit) - the interface between the BTS (Base Transceiver Station) Via the

Donor Antenna and the RAC .

• RAC (Remote Antenna Controller)- Up link and Down link amplifiers with programmable

attenuators. Control card for C&M of the whole FLEXBEAMER® system.

• PCS FLEXBEAMER® (Coverage Enlightener BEAMER - The main amplifier unit includes

two Beamers, dividers, combiners and a duplexer. This unit is connected to the sector antenna.

BAU RAC CEB

Donor

Antenna

Distributing

Antenna

U.L

D.L

Figure 1: Repeater Simplified Block Diagram

1.1. BEAMER

Module Concept

The BEAMER

is an integrated active antenna for wireless communications. It incorporates a

transmission amplifier, Remote Controlled Gain, transmission band filter and the respective receive

chain: band filter, and Gain controlled LNA.

The Tx amplifier is linear. The Rx amplifier has an exceptional linear dynamic range. The integral unit

contains its own power conditioner and a monitoring and control circuit that communicates with the

RAC and from there on through the Wireless Modem to any remote PC (The Wireless Modem feature

is an option) . The whole unit is sealed and built as a plug-in replaceable unit. The design and

production techniques offer low price and high reliability.