User Manual

Confidential, Proprietary Information
Title: PCS FlexBeamer
®
RF Repeater
System A &O Manual
Doc. No.:
913002500
Rev.: 00
Page: 22 of
80NUMPAGES
• Rx Phase control
• CTRLR status
• Manual control of selected BEAMER
®
PA ON/OFF state and DCA
Attenuation values.
• Control ABTs Gain states
• Monitor ABTs amplifiers well being by monitoring the ABTs currents.
• Checks the +24V internal Supply.
• Software upgrade Download into a selected BEAMER
®
module and the
Control Card Remotely
• Faults indication Register which saves the Fault Indications History to be read
remotely when required.
1.6. Power Distribution
The Repeater System is powered by connecting the AC power supply line to the AC connections in the
panel of the RAC. DC voltage is supplied via the Tx and Rx coaxial cable coming up from the RAC to
the FLEXBEAMER® and BAU for system operation.
Power Source 110/220VAC or +24VDC up to 400Watt
ACBT Max. Current
Consumption
Up to 200mA @ +24VDC with no FLEXBEAMER® or BAU
connected (DC)
Max. Current per BEAMER
®
Ver.3.2 (in FLEXBEAMER®)
Up to 3Amp. @ +24VDC
Max. Current per BEAMER
®
Ver.3.2 M (in BAU)
Up to 1Amp. @ +24VDC
RAC Connectors
Tx Connector to FLEXBEAMER® unit N-type connector, female
Tx/Rx Connection to BAU N-type connector, female
Rx Connector to FLEXBEAMER® unit N-type connector, female
RS-485 connector Amphenol 7 pins female sealed connector
AC/DC Connector Amphenol 7 pins male sealed connector
Grounding Connection By physically Wiring the RAC to pole grounding