User Manual

Confidential, Proprietary Information
Title: PCS FlexBeamer
®
RF Repeater
System A &O Manual
Doc. No.:
913002500
Rev.: 00
Page: 32 of
80NUMPAGES
3. FLEXBEAMER® RF REPEATER SYSTEM
SET-UP AND TUNING
3.1. FLEXBEAMER® RF Repeater System Set Up
The following set of procedures will guide you through the proper and full system set-up. Please follow
these steps in the order given herein.
3.1.1. AC Wiring
Ø The RAC should be connected to 24VDC power supply or to 115/220 VAC(as an option). A
cable with a minimum of 16 AWG inner wires gage should be used.
Ø The AC or DC power will be connected to the 7 pin Amphenol sealed connector on the RAC
bottom panel.
Ø Please use an UL cable to connect the RAC to AC outlet.
Ø The RAC included resettable Fuses located inside the box. In order to reset the fuses it is
needed to turn OFF and back ON the mains power.
Remember to disconnect the RF drive (or to turn the RF drive OFF) before turning the AC power
ON.