User Manual

Confidential, Proprietary Information
Title: PCS FlexBeamer
®
RF Repeater
System A &O Manual
Doc. No.:
913002500
Rev.: 00
Page: 35 of
80NUMPAGES
The following sections describe how to configure the system step-by-step.
3.1.3.1. Set RAC Operation Mode
The RAC configuration setup can only be changed through the BSM S/W The default RAC
configuration is AUTO by a manufacturer internal pre-defined switch.
3.1.3.1.1. Checking the RAC System Address and RAC ID
The RAC system address and the RAC ID can be easily checked. To RAC ID and address are
manufacturer pre defined parameters.
You can read the RAC system address and its ID as follows:
From the BSM main screen enter to “setting/ICU” setting and you will get the ID number and
address.
Note: RAC system address ranges are 01 to 04. RAC address 00 is reserved
for system configuration and should not be used.
3.1.3.2. Configuring the Number of BEAMER
®
Arrays
The system definition command is used to configure the number of connected BEAMER
®
arrays (for this purpose a FLEXBEAMER® and BAU are considered as BEAMER
arrays).
Use this command to set the number of installed arrays to 3
Sub Array No. 2,5 for Main
Sub Arrays No. 3,4 for Diversity
Sub Arrays No. 1,6 for BAU
Note: Issuing the 'save system features' command will erase the previous
BEAMER
®
configuration. Previous definitions of arrays and Bias-T
assignments must be reprogrammed, following this command.
3.1.3.3. Bias-T Definitions and type
Once the arrays are configured, a Bias-T must be assigned for each array. The “Settings/Array
setting/Sub array setting” is used for assigning the Bias-T for the arrays. For example, Array
without Rx diversity will need Rx and Tx Sub arrays.
3.1.4. Setting the Bias-T Attenuation
Bias-T attenuation, for either Rx or Tx Bias-T, can be modified by entering to the desired
Array from the main screen and entering to one of the sub arrays and by hitting pause and
changing attenuation value and apply.