User Manual

Confidential, Proprietary Information

Title: PCS FlexBeamer

RF Repeater

System A &O Manual

Doc. No.:

913002500

Rev.: 00

Page: 40 of

80NUMPAGES

3.1.9. FLEXBEAMER® System Sector Installation Record

After setting the FLEXBEAMER® RF Repeater system, it is recommended to write down the

site information for remote control records.

Repeater #..........................................

RAC address...................................... RAC ID number (from unit label)

FLEXBEAMER® (Array) Number .... BAU (Array) Number………………..

3.1.9.1. Installed BEAMER

Modules

Unit#1 ID(from unit label).................. system address …………

Unit#2 ID (from unit label)................. system address …………

Unit#3 ID (from unit label)................. system address ………….

RAC BEAMER

Unit # (from label)_….. , System Address ……………..

3.1.9.2. Estimated RF Cable Loss

Tx RAC to FLEXBEAMER® (main). dB

Tx RAC to FLEXBEAMER® (diversity) dB

Rx FLEXBEAMER® to RAC (main). dB

Rx FLEXBEAMER® to RAC (diversity) dB

Tx BAU to RAC ................................ dB

Rx FLEXBEAMER® to BAU ........... dB

Donor Ant. to BAU ............................ dB

FLEXBEAMER® Main to Ant. ......... dB

FLEXBEAMER® Div. to Ant............ dB

3.1.9.3. Down Link Channel parameters

Ec power level at Donor Antenna........ dBm …………

RAC Down Link gain......................... dB…………..

BAU Down Link gain......................... dB …………..

FLEXBEAMER® BEAMER

measured output power:

Beamer 1 ........................................... dBm

Beamer 2 ........................................... dBm

Average ............................................. dBm

3.1.9.4. Up Link Channel Parameters

Up Link LNA gain setting for the FLEXBEAMER®…………..dB