User Manual

Confidential, Proprietary Information
Title: PCS FlexBeamer
®
RF Repeater
System A &O Manual
Doc. No.:
913002500
Rev.: 00
Page: 47 of
80NUMPAGES
 BEAMER
®
monitoring and control
4.2.2. System Menu List
The SYSTEM menu list provides the functions to set system parameters. It consists of four menus:
Definition, Configuration, Array Control and Com port
4.2.2.1. System definition Menu
The Capacity menu enables definition of the number of arrays in the system and type of array.
4.2.2.2. Configuration Menu
The Configuration menu enables:
 Registration of new BEAMER
®
units in the system..
 Display the ID number of each BEAMER
®
unit in the system.
 Definition of the conditions for failure messages.
 Definition of the shutdown conditions for the Power Amplifiers.
 Definition of status limits for failure messages (displayed by the RAC , the user
interface and sent to the BEAMER
®
concentrating unit).
4.2.2.3. Com Menu
The Com menu enables selection of an available serial port
4.2.2.4. Array Control
The Array Control menu enables setting the gain for each Active Bias T (ABT) in the system.
4.2.2.5. Password Menu List
The Password menu list enables entering the password to apply changes in system configuration.
Four levels of security password are available:
1. "Guest" level can only observe indications.
2. "Operator" level can apply changes to System configuration setting menu and BEAMER
®
setting menu in addition to "Guest" abilities.
3. "Supervisor" level can apply changes to the system settings, such as Capacity/Failure conditions
and Limit/Shutdown conditions, in addition to the "Operator" abilities.
4. "Administrator" can change the passwords in addition to "Supervisor" abilities.