User Manual

Confidential, Proprietary Information
Title: BEAMER Array System-
Assembly and Operation Manual
Doc. No.: 913002500 Rev.: 00
Page: 71 of 80
6. Exit to save the log file or Click O.K to continue. The properties of the existing file will be
displayed on RAC Software properties field.
7. Click on the Password menu then on Enter to enter the password that enables loading of a new
program. After you enter the correct password and your name the Start download command key
will be enabled.
8. Click the Start download command key to start the loading process. The following window will
be displayed:
9. Select the required file and click on the Open button. If the selected file is similar to the existing
(operational) file then following notice will be displayed:
10. If you wish to load the same file anyway then click Yes to continue, otherwise click No and select
other file.
11. During the loading process a status bar will be displayed:
12. Wait about 3 minutes until the process is completed. If you wish to stop loading the file then
click on the Cancel button.
13. After the file has been loaded into the RAM successfully the RAC will program the FLASH
memory. During the FLASH programming the following message will be displayed:
14. The new program version will operate at the end of this process and the RAC is operational
again.
15. If the loading process has been failed the following warning message will be displayed: