User Manual

Confidential, Proprietary Information
Title: BEAMER Array System-
Assembly and Operation Manual
Doc. No.: 913002500 Rev.: 00
Page: 75 of 80
System Alarms 1. Enter to the Beamer status screen and verify PA is “ON”
2. Look for alarms in one of the two defined arrays.
3. If PA is “OFF” try to turn it “ON”.
4. If you can not do so go to the Sub-array (ABT) “Attenuator
settings and increase the attenuation to avoid possible over drive
power to the Beamers.
5. If PA can be turned “ON” start system setup from the
beginning.
• If PA does not go “ON” replace the faulty unit.