User's Guide

Cellular Transmission Solutions
P.O.Box 106, Tavor building 1
Yoqne’am Ilit 20692, ISRAEL
Tel. + 972 4 9592522
Fax. + 972 4 9592523
E
-
mail: [e-mail]
4
Multicarrier PCS Beamer Concise User-Guide
No. 913002900
13. To test the Main Rx path, disconnect J9, the Diplexer antenna connector, from the loads of
the Tx test and connect J9 to a –30 dBm signal source. Connect J3, the Main Rx Out port, to
the appropriate test load, e.g. spectrum analyzer.
14. To test the Diversity Rx path, connect J6, the Rx Diversity In port to the –30 dBm signal
source and J5, the Rx Diversity Out port, to the test load.
15. To change the gain setting of any path, click on F4: Main Rx Attenuator, F5: Div. Rx
Attenuator, or on F6: Tx Attenuator, as appropriate. In each case, a slide control will open up
as illustrated in Figure 5. The slide can be moved by either sliding the Mouse over it or
clicking on the Inc+ or Dec – buttons. When the desired attenuation is set click OK in the
same window . The gain control range is 15.5 dB in 0.5 dB steps.
Figure 1