User Manual
Table Of Contents
- CONTENTS
- FIGURES
- TABLES
- INTRODUCTION
- INSTALLATION GUIDE
- Applicable Documents
- Scope
- Important Safety Precautions
- ICU Operation Instructions
- Array Installation
- Assembly Instructions for the PCS 1x4x4 Array
- PCS 1x8x8 Array Assembly Instructions
- Beamer System Setup
- BEAMER System Sector Array Installation Record
- Test Procedure for Measuring the Rx Gain Balance
- Smart-Terminal Program Description
- BSM (BEAMER SYSTEM MANAGER) PROGRAM
- Functions
- Requirements for Operation
- User Interface Description
- Status Reports
- BSM S/W
- BSM Main Screen
- Comm Port Selection
- Password Entering
- Host Selection
- Installation of ICU in System
- Failure Conditions Selection
- BEAMER Limits Definition
- Shut Down Conditions Enable/Disable
- ICU Limits Definition
- System Definition
- Sub-Array and BEAMER Setting
- Sub Array Setting
- BEAMER Installation
- Column and Row Definition
- Sub-Array Status and Attenuator Setting
- Control & BEAMER Setting
- BEAMER Control
- ICU Status
- ICU CTRLR Status
- ICU Properties
- SOFTWARE DOWNLOAD GUIDE
- WARRANTY
- Exclusions
- Warranty Limitations
- INDEX
Proprietary Information
Title: BEAMER Array System-
Assembly and Operation Manual
Doc. No.: 913000101 Rev.: 1
Page: 3 of 92
Revision Description Date
0 Release May, 2000
1
F
CC part 15 statemnet & power level modification May 2001
Changes are periodically made to the information contained in this manual. These changes are published in the
"software/hardware release notes", and will be incorporated into new editions. All rights are reserved. No parts of
this manual may be reproduced in any form, without permission in writing from Celletra Ltd.
Copyright
©
1999, 2000 Celletra Ltd.
BEAMER is a trademark of Celletra Ltd.
Celletra Ltd. reserves the right to change specifications without notice.