User Manual
Table Of Contents
- CONTENTS
- FIGURES
- TABLES
- INTRODUCTION
- INSTALLATION GUIDE
- Applicable Documents
- Scope
- Important Safety Precautions
- ICU Operation Instructions
- Array Installation
- Assembly Instructions for the PCS 1x4x4 Array
- PCS 1x8x8 Array Assembly Instructions
- Beamer System Setup
- BEAMER System Sector Array Installation Record
- Test Procedure for Measuring the Rx Gain Balance
- Smart-Terminal Program Description
- BSM (BEAMER SYSTEM MANAGER) PROGRAM
- Functions
- Requirements for Operation
- User Interface Description
- Status Reports
- BSM S/W
- BSM Main Screen
- Comm Port Selection
- Password Entering
- Host Selection
- Installation of ICU in System
- Failure Conditions Selection
- BEAMER Limits Definition
- Shut Down Conditions Enable/Disable
- ICU Limits Definition
- System Definition
- Sub-Array and BEAMER Setting
- Sub Array Setting
- BEAMER Installation
- Column and Row Definition
- Sub-Array Status and Attenuator Setting
- Control & BEAMER Setting
- BEAMER Control
- ICU Status
- ICU CTRLR Status
- ICU Properties
- SOFTWARE DOWNLOAD GUIDE
- WARRANTY
- Exclusions
- Warranty Limitations
- INDEX
Proprietary Information
Title: BEAMER Array System-
Assembly and Operation Manual
Doc. No.: 913000000 Rev.: 00
Page: 61 of 92
3. BSM (BEAMER SYSTEM MANAGER)
PROGRAM
3.1. Functions
The BSM program enables monitoring and control of the BEAMER units form a local or remote PC
based host computer.
Its main functions are:
Status report for each Array
Status report for each BEAMER
Control of system capacity and configuration
Control of each BEAMER
Monitoring & Control of the ICU functions and Active Bias-Ts
Setting the Active Bias-T amplifiers gains for Tx and Rx channels.
3.2. Requirements for Operation
3.2.1. Hardware
A Pentium
TM
based PC and a serial port on the PC
3.2.2. Software
Window 95/98/NT operating system