User Manual
Table Of Contents
- CONTENTS
- FIGURES
- TABLES
- INTRODUCTION
- INSTALLATION GUIDE
- Applicable Documents
- Scope
- Important Safety Precautions
- ICU Operation Instructions
- Array Installation
- Assembly Instructions for the PCS 1x4x4 Array
- PCS 1x8x8 Array Assembly Instructions
- Beamer System Setup
- BEAMER System Sector Array Installation Record
- Test Procedure for Measuring the Rx Gain Balance
- Smart-Terminal Program Description
- BSM (BEAMER SYSTEM MANAGER) PROGRAM
- Functions
- Requirements for Operation
- User Interface Description
- Status Reports
- BSM S/W
- BSM Main Screen
- Comm Port Selection
- Password Entering
- Host Selection
- Installation of ICU in System
- Failure Conditions Selection
- BEAMER Limits Definition
- Shut Down Conditions Enable/Disable
- ICU Limits Definition
- System Definition
- Sub-Array and BEAMER Setting
- Sub Array Setting
- BEAMER Installation
- Column and Row Definition
- Sub-Array Status and Attenuator Setting
- Control & BEAMER Setting
- BEAMER Control
- ICU Status
- ICU CTRLR Status
- ICU Properties
- SOFTWARE DOWNLOAD GUIDE
- WARRANTY
- Exclusions
- Warranty Limitations
- INDEX
BSM (BEAMER SYSTEM MANAGER) PROGRAM
Proprietary Information
Title: BEAMER Array System
Assembly and Operation Manual
Doc. No.: 913000100 Rev.: 00
Page: 64 of 92
3.5. BSM S/W
The BSM Software enables system configuration and monitoring functionality of each unit in the
system.
Operation of the software will be described in the following paragraphs.
3.5.1. S/W Installation
The software installation is from diskette that supplied by Celletra .
• Put disk no.1 in the floppy drive and run "Setup".
• Follow the instructions on the screen until completion of installation.
3.5.2. S/W Operation
From the "Program files" in the Windows operating system select the BEAMER icon and operate the
software.
Follow the next steps in order to establish a correct system installation.
3.6. BSM Main Screen
From the
Setting menu
select the
Comm port.