User guide

Remote control (continued)

Installing Batteries in the Remote Control

1. Remove the battery compartment cover at the rear of the remote

control by pushing the retaining clip forward and pulling up.

2. Install the supplied batteries, ensuring the polarity matches what

is shown in the battery compartment.

3. Replace the battery compartment cover.

Using the Remote Control

To use the remote control point it at the TV and press the required buttons. You must

be within 6 meters and at an angle of less than 30 degrees from the center of the TV.

NOTE: Sunshine or other strong light sources may interfere with the signal from the

remote control. In this situation turn the TV away from the light source.

WARNING! DO NOT LEAVE BATTERIES IN THE REMOTE CONTROL FOR

EXTENDED PERIODS AS THEY CAN LEAK OR CORRODE CAUSING DAMAGE

TO THE REMOTE CONTROL. CHECK THEM PERIODICALLY AND REPLACE

THEM AS REQUIRED.

WARNING! DO NOT MIX BATTERY TYPES. WHEN INSERTING BATTERIES,

REPLACE ALL BATTERIES AT THE SAME TIME. DO NOT MIX OLD AND NEW

BATTERIES.

WARNING! EXHAUSTED BATTERIES MUST BE TREATED WITH CARE AND

DISPOSED OF ACCORDING TO ANY SAFETY OR RECYCLING REGULATIONS

IN FORCE IN YOUR LOCAL AREA, NEVER DISPOSE OF BATTERIES INTO

GENERAL WASTE, OR FIRE.

WARNING! NEVER EXPOSE BATTERIES TO EXCESSIVE HEAT SUCH AS

SUNSHINE, FIRE OR THE LIKE.