User manual

11
Troubleshooting
If the problem persists, contact the retailer if the soundbar is still under guarantee.
PROBLEM
POSSIBLE SOLUTION
No Power
• Ensure the mains plug is connected to a power supply, and is switched ON.
• Make sure there is power to the mains socket.
No Sound
• Make sure if playing from the AUX input, the external source has the volume turned up
and is playing a track.
• Make sure the volume is turned up.
• If using the digital coaxial cable connection ensure the source DIGITAL output is set to
PCM, LPCM, PCM 2Ch stereo or PCM downmix.
No response from the unit
• Unplug the power cable for 1 minute then plug back in again.
Remote control does not work
• Reduce the distance between the remote and main unit
• Check the batteries are installed correctly.
• Replace the batteries
• Point the remote directly at the Sound bar
SPECIFICATIONS
NAME
UNITS
Amplifier Power Output
2 x 15 W + 30 W (Subwoofer) @ 1% THD
Frequency Response
20Hz – 20 KHz (+/-) 3dB
Input sensitivity (mV)
500 mV rms
Inputs
SPDIF Coaxial (rear), 3.5 mm Mini-jack
Voltage
110 – 240 V~, 50/60 Hz
Standby Power Consumption
Less than 0.5 W
Full range Speaker Drivers
Subwoofer
Impedance: 8 Ohm
52mm (2”)
Frequency Response: 160 Hz – 20 KHz
Impedance: 4 Ohm
78mm (3”)
Frequency Response: 55 – 160 Hz
Storage Temperature
32F – 140F