Install guide

5
Option 2
1. When location of outside antenna has been determined, remove cap from
ferrule side hole.
2. Feed FME connector (small end) and cable through side hole on the f
shown in the gure below.
3. Feed remainder of cable through ferrule hole until approximately 1” of cable
remains.
4. Connect N connector to antenna.
5. Screw antenna onto ferrule, bend cable to prevent cable from twisting.
6. Screw base onto other end of ferrule.
7. Mount base onto location.
INSTALLATION
1
2
1
2
1
2
N connector
FME connector
1
2
N connector
3