User's Manual

-16-
of the phone kept 0.5cm from the body. To comply with FCC RF exposure
requirements, a minimum separation distance of 0.5cm must be maintained
between the user's body and the back/front of the phone, including the
antenna. Third-party belt-clips, holsters and similar accessories containing
metallic components shall not be used. Body-worn accessories
 that cannot maintain 0.5cm separation d istance between the user’s body
and the back/front of the phone, and have not been tested for typical
body-worn operations may not comply with FCC RF exposure limits and
should be avoided.
 For more information about RF exposure, please visit the FCC website at
www.fcc.gov
 Your wireless handheld portable telephone is a low power radio transmitter
and receiver. When it is ON, it receives and also sends out radio frequency
(RF) signals. In August, 1996, the Federal Communications Commissions
(FCC) adopted RF exposure guidelines with safety levels for hand-held
wireless phones. Those guidelines are consistent with the safety standards
previously set by both U.S. and international standards bodies:
 <ANSIC95.1> (1992) / <NCRP Report 86> ( 1986) / <ICNIRP>
(1999)
 Those s tandards were based on comprehensive and periodic evaluations
of the relevant scientific literature. For example, over 120 scientists,
engineers, and physicians from universities, government health agencies,
and industry reviewed the available body of research to develop the ANSI
Standard (C95.1). Nevertheless, we recommend that you use a hands-free
kit with your phone (such as an earpiece or headset) to avoid potential
exposure to RF energy. The design of your phone complies with the FCC
guidelines (and those standards).
 Use only the supplied or an approved replacement antenna. Unauthorized
antennas, modifications, or attachments could damage the phone and may
violate FCC regulations.
 NORMAL POSITION:
 Hold the phone as you would any other telephone with the antenna pointed
up and over your shoulder.
 RF Exposure Information:
 This product is compliance to FCC RF Exposure requirements and refers to
FCC websitehttps://apps.fcc.gov/oetcf/eas/reports/GenericSearch.cfm
search for FCC ID:2AC83ZOCAD42Z to gain further information include