Installation Guide

101
gutter warrior
Installing Gutter
Warrior
™
1. Insert the front of Gutter Warrior
™
inside the front of the gutter.
(Fig. 1)
2. Insert the back of Gutter Warrior
™
on the back of the gutter. (Fig. 2)
3. Make sure that each section
of Gutter Warrior
™
overlaps
perfectly. (Fig. 3)
4. To install an outside corner, stop
the section of Gutter Warrior
™
5-8" from the outside corner,
leaving a space to apply the gutter
sealant. (Fig. 3a)
To install an inside corner, stop
the section of Gutter Warrior
™
5-8" from inside corners, leaving
a space to apply the gutter sealant.
(Fig. 3b)
5. Using an end-cap crimping tool,
pinch the back of the Gutter
Warrior
™
and the gutter every 3'
feet to stabilize them. (Fig. 4)
6. Stop the Gutter Warrior
™
sections
inside the end cap to prevent
water overflow. (Fig. 5)
7. Insert the back of the gutter under
the drip edge (flashing). (Fig. 6)
8. Screw the back of the Gutter
Warrior
™
into the fascia board
every 24" using the self-sealing
screws. (Fig. 7)
Installing Gutter Warrior
™
in Corners
1. Use a Gutter Warrior
™
prefab
corner (IC5220 or OC5220).
2. Make sure that the prefab corner
overlaps the sections of Gutter
Warrior
™
on both sides.
IMPORTANT NOTES:
• Forinsidecornersandvalleys,
install a water diverter
(ASDIV J0) directly on the
Gutter Warrior
™
surface.
• Downspoutsor3"x4" are
recommended in areas with
conifer (pine) trees.
• Theflowfromhigh-levelgutters
must be transferred within
downspouts directly into lower-
level gutters.
• ToinstallGutterWarrior
™
with
longer flashings (2" or more), skip
installation Steps 2 and 5, placing
both the flashing and the Gutter
Warrior
™
foldover inside the
gutter.
gutter warrior
Fig. 3
5"-8"
Fig. 3a
Fig. 1
Fig. 2
Fig. 5 Fig. 6
Fig. 7
Fig. 4
5-8"
Fig. 3b