Installation Guide

installation
cedar discovery
Replacing A Damaged Panel
To repair or replace a damaged panel,
unlock panel above the damaged
panel in order to expose nail hem of
damaged panel.
NOTE: This can be done by either
pulling out at bottom lock with your
hand, or using a Hook & Cotter Pin
Puller Tool (NAPA Auto Parts No.
3470 or equivalent) (Fig. 2).
Remove nails from damaged panel,
and unlock from previous course.
(Fig. 3).
Install replacement panel by
locking into course below, then
nailing according to “NAILING
PROCEDURES”.
Using a Hook & Cotter Pin Puller
Tool (NAPA Auto Parts No. 3470 or
equivalent), start at the left end of the
panel, and begin locking the panel
above to the new installed panel
(Fig. 1).
NOTE: For best results, engage 3
" -4 "
of lock at a time, continuing from left
to right along the length of the panel.
Fig. 1
Fig. 2
Fig. 3
81