Installation Guide

half-round gutters
leaf relief
96
For Inside Corners
Use perforation pattern as a guide to
create corners. Using tin snips, cut
diagonally along the perforation to
create a 45° angle, starting at the rear
edge and cutting as shown. Notch
and remove one inch of the front
edge from the newly formed angle
(Fig. 1).
When mounted, the pieces will over-
lap one inch and form a 90° inside
corner. Place one screw through the
overlapping pieces (Fig. 2).
NOTE: To prevent overflow, all
inside corners and valleys must have
a water diverter/deflector. Diverter/
deflector must be installed on the top
surface of Leaf Relief
®
.
Fig. 1
Fig. 2
Mitering Corners continued