Installation Guide

leaf relief
leaf relief
80
Installing Leaf Relief
®
on Half-Round Gutters
continued
Mitering Corners continued
For Inside Corners:
Use perforation pattern as a guide to
create corners. Using tin snips, cut
diagonally along the perforation to
create a 45° angle, starting at the rear
edge and cutting as shown. Notch
and remove one inch of the front
edge from the newly formed angle
(Figure 1).
When mounted, the pieces will
overlap one inch and form a 90°
inside corner. Place one screw
through the overlapping pieces
(Figure 2).
NOTE: To prevent overflow, all
inside corners and valleys must have
a water diverter/deflector. Diverter/
deflector must be installed on the top
surface of Leaf Relief
®
.
Fig. 1
Fig. 2