Installation Guide

84
Sectional Gutters and
Accessories Hangers
Determine which of these hanger
systems will work best. All hangers
should be attached with two 1-1/4"
stainless steel screws or screw shank
aluminum nails.
Snug Fit Hanger
This hanger is ideal for remodeling
use where it is necessary for the back
leg of the gutter to fit tightly under
roof shingles. A chalk line should
be struck along the fascia to act as a
guide when installing these hangers.
These hangers will allow the gutter
to be installed level or with a slight
slope. After all hangers are installed,
the gutter is attached by engaging the
front lip of the gutter into the front lip
of the hanger and rotating the back
leg of the gutter up against the fascia.
The clip at the back of the hanger
should be loosened so that it is free to
slide under the lip on the back leg of
the gutter. Once the clip is engaged
in the back leg of the gutter, the nut
and bolt should be tightened.
Combination Hanger
This hanger is ideal for both
remodeling and new construction
use. A chalk line should be struck
along the fascia to act as a guide
when installing these hangers. These
hangers can be installed level or with
a slight slope. Once the hangers are
installed, the gutter is attached by
engaging the front lip of the gutter
into the front lip of the hanger and
rotating the back leg of the gutter
up against the fascia so that the two
hooks on the back of the hanger lock
into the lip on the back of the gutter.
Strap Hanger
Use in combination with roof or
fascia apron* – This combination
is ideal for new construction and
re-roofing applications. In lieu of
a drip edge, the roof apron should
be installed continuously along the
edge of the roof above the fascia
and nailed every 16" with 1-1/4"
aluminum nails through the top
flange of the roof apron. The gutter is
then attached by sliding the back leg
of the gutter up under the roof apron
so that the lip on the gutter locks into
the hook portion of the roof apron.
Once the gutter is locked up along
the entire length of the roof apron,
strap hangers can be installed by
engaging the front of the strap hanger
into the front lip of the gutter and
rotating the other end of the hanger
down into the roof surface. This
type of installation is designed for
level applications of gutter or an
application which is parallel to the
roof edge of fascia.
*NOTE: Roof apron is not applicable
for slopes greater than 6:12. Hanger
is to be installed on roof sheathing
under shingles.
gutters and downspouts
gutters and hangers
5" 6"
Hanger
OG91
N/A
Leaf Relief
®
TP53ZIP
Fig. 1
Install Snug Fit Hangers
Every 32" or Less
5" 6"
Hanger OG101 OG1061
Leaf Relief
®
TP53ZIP N/A
Fig. 2
Install Combination Hangers
Every 48" or Less
5" 6"
Hanger OG111 OG1161
Leaf Relief
®
See page 91 See page 91
Fig. 3
Install Strap Hangers
Every 48" or Less