Installation Guide

gutters and downspouts
88
Step 1
Attach an elbow to the eave tube, drill
holes and rivet the elbow to the eave
tube with aluminum rivets. (Fig. 1)
Measure and square off the downspout
cutting it with either a hack saw or
power saw.
It may be necessary to use a second
piece of downspout to connect the
downspout with the eave tube. If so,
rivet all three together, otherwise rivet
the downspout directly to the eave
tube.
Measure for the downspout clamp.
Step 2
Make a 3/4" hole through the siding
only using a boring bit. (Fig. 2)
Step 3
Nail or screw the clamp through the
center of the oversized hole. (Fig. 3)
Step 4
Attach the downspout to the clamp
and rivet. (Fig. 4)
Fig. 1
Fig. 2
Fig. 3
Fig. 4
gutters and hangers
Installing the Downspouts