Installation Guide

mitered corners
98
Outside Corners
Use perforation pattern as a guide
to create corners. Using tin snips,
cut diagonally along the perforation
to create a 45° angle, starting at the
outside edge and cutting as shown,
through the plastic strip. Notch and
remove one inch of the front edge
and plastic strip from the newly
formed angle. When mounted, the
pieces will overlap one inch and
form a 90° outside corner. Place
one screw through the overlapping
pieces. Attach to back through plastic
strip, with screws, 2" from the point
of the corner. (Fig. 1 & 2)
Inside Corners
Use perforation pattern as a guide
to create corners. Using tin snips,
cut diagonally along the perforation
to create a 45° angle, starting at the
rear edge (plastic strip) and cutting
as shown, until complete. Notch and
remove one inch of the front edge
and plastic strip from the newly
formed angle. When mounted, the
pieces will overlap one inch and
form a 90° inside corner. Place
one screw through the overlapping
pieces. Attach to back through plastic
strip, with screws, 2" from the point
of the corner.
Or use bendable 1" x 6" support
(V-Support) beneath areas where
no hanger exists.
Important
To prevent overflow, all inside
corners and valleys must have
a water diverter/deflector, sold
separately. Diverter/deflector must
be installed on the top surface of the
Leaf Relief
®
(behind front lip).
(Fig. 3, 4, 5)
1" 1"
1" 1"
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
leaf relief
Leaf Relief
®
Installation (Mitered Corners)