Installation Guide

leaf relief
99
tp53zip / tp63zip
Outside Corner
Use the perforated pattern to cut a
45° angle at the ends of the Leaf
Relief sections. Then cut away 1"
from the front, first step and back
of one section as shown.
Overlap sections by 1 " and attach
witha#6x3/8 " stainless steel screw.
(Fig. 1, 2, 3)
Use bendable support (V-Support)
beneath areas where no hanger
exists or place a screw through the
plastic flap.
Inside Corner
NOTE: Because ZIP product has
a stepped profile, pre-fabricated
corners cannot be used.
Use the perforated pattern to cut a
45° angle at the ends of the Leaf
Relief sections. Then cut away
1 " from the front and back of one
section as shown.
The sections will overlap by 1
" and
beattachedwitha#6x3/8 " stainless
steel screw. (Fig. 4, 5, 6)
Use bendable support (V-Support)
beneath areas where no hanger
exists or place a screw through the
plastic flap.
Fig. 4
Fig. 5
Fig. 6
Fig. 1
Fig. 2
Fig. 3
TP53ZIP / TP63ZIP