Installation Guide

starter strip and accessories
insulated siding installation
Cut the starter strip back from each
corner so the corner post nailing hem
may be installed without touching the
starter strip. Leave a 1/2" gap from
all corner post nail hems.
Cut the corner post so that it hangs
3/4" below the bottom of the starter
strip. (Fig. 1)
When installing panels above
exposed overhang areas, the 3-1/2"
steel starter strip can be modified by
bending the starter in two locations
as shown. (Fig. 2)
1/2"
Steel Starter Strip
1-3/8"
1-3/8"
5/8"
90ϒ
90ϒ
Fig. 1
Fig. 2
51
Starter Strip and Accessories