Owner's manual

Pos. A

Pos. B

I 0184 - 8

5 -INDICATION AND USE OF THE WHEEL BALANCER

5.1 - DOUBLE OPERATOR PROGRAM

This program allows memorizing the dimensions of two types of wheels. Thus two operators can work

simultaneously on two different cars using the same balancing machine. The system memorizes two

programs with various preset dimensions.

1 - Press

to select operator (1 or 2). Selection is conﬁ rmed by panel-mounted Led.

2 - Enter the dimensions (see PRESETTING OF WHEEL DIMENSIONS).

3 -

perform balancing as usual

With

program 1 or 2 is called for subsequent balancing operations without having to newly enter

the dimensions.

5.2 PRESETTING OF WHEEL DIMENSIONS

5.2.1 - (Automatic presetting C61Z )

- Standard wheels (calibration necessary also for modes ALU 1, 2, 3, 4, Static)

Fig. 5 DISTANCE + DIAMETER

Move the gauge tip into contact against the rim (ﬁ g. 5) keeping it in position

for at least 2 seconds.

Note: Measurement is identical in position A or B. Always use the round part

of the striking block.

Indication of gauge in movement Fig. 5A

Indication of dimension acquired Fig. 5B

Note: If the acoustic signal is enabled (see

OPERATION FUNCTIONS MENU), the

acquisition of the dimensions is accompanied by a “beep”

Return the gauge to position 0.

The system automatically switches to WIDTH position.

Fig. 6

- Set the rated width, which is generally

indicated on the rim, or measure width

“b” using the compass gauge supplied.