User Manual Instruction Manual

Use and maintenance manual Rev. 01-2011

ENGLISH

Starting

3. Starting

WARNING

BEFORE SWITCHING ON THE MACHINE, MAKE SURE THAT ALL THE

CONNECTIONS DESCRIBED IN THE INSTALLATION CHAPTER

HAVE BEEN MADE CORRECTLY.

THE FOLLOWING OPERATIONS INVOLVE A POTENTIAL RISK FOR

THE OPERATOR, GIVEN THE PRESENCE OF VOLTAGE ON THE

EQUIPMENT. THE PERSONAL PROTECTIVE EQUIPMENT DESCRIBED

IN THE INSTALLATION MANUAL MUST BE WORN AND WORK

MUST BE DONE WITH DUE CARE AND ATTENTION.

OPERATIONS MAY ONLY BE PERFORMED BY A

SPECIALISED TECHNICIAN.

Before powering the machine, carry out the following

checks:

check that the balancing machine touches the floor 1.

at the three support points;

2. make sure that all the parts of the balancer are cor

rectly connected and fixed;

3. make sure that the parameters (voltage and frequency)

of the mains power supply are compatible with those

indicated on the rating plate of the balancer;

4. make sure the power cable is correctly connected;

5. make sure the machine shaft and flange hole are

clean.

CAUTION

ANY TRACES OF DIRT MAY AFFECT BALANCING ACCURACY.

6. To switch on the balancer press the switch on the

left-hand side of the machine.

7. Position the wheel on the terminal with the inner part

facing the balancer;

8. Firmly attach the wheel to the balancer shaft using

the lock nut.

9. At this point, you can read the tyre measurements

and perform balancing.