User Manual

I 0369 - 4

I 0369 - 5

2 2a

�

1.4 - Technical data

Note: DO NOT LIFT THE WHEEL BALANCER USING OTHER GRIPS

Single-phase power supply 115 / 230 V - 50/60 Hz

Protection class IP 54

Max. power absorbed 0,8 Kw

Balancing speed < 100 min

-1

Cycle time for average wheel (14 kg) 6-8 seconds

Max. resolution of measurement 1 gram

Position resolution ± 1.4 °

Average noise < 70dB (A)

Rim-machine distance 0 - 252 mm

Rim width setting range 1.5” - 20” or 40 - 510 mm

Diameter setting range 10” - 26” or 265 - 665 mm

2 - Handling and lifting

3 - Startup

3.1 - Anchoring

The machine can operate on any  at non resilient  oor.

Make sure that the machine rests solely on the three support points provided (Fig.2a).

It is advisable to secure the system to the ground using the speci c feet (Fig. 2a). if the machine is

continually used with wheels weighing over 35 kg.

3.2 - Electrical connection

The machine is supplied with a single-phase mains cable plus earth (ground).

The power supply voltage (and mains frequency) is indicated on the machine identi cation plate and cannot be

changed.

Connection to the mains must always be made by expert personnel.

The machine must not be set up without proper earthing.

Connection to the mains should be through a slow acting safety switch rated at 3 A (230V) or 8 A(115 V).

See enclosed diagram.