Specifications

▲
!
CAUTION: the automatic switch is
equipped with protection against motor over-
heating; should the motor overheat the relay
cut-out setting, the switch will move into the
"0" position. At this stage, if the thermal
conditions are correct, the switch will have to
be re-set manually.
9.1.5) Press automatic switch (04) in position " I " (Fig. 18) to start the motor.
04
9.1.4) Before starting any work, press the
test push-button (90) (Fig. 17d) to
check the battery condition (see § 4).
Make sure drill switch (04) is in
position “0” (Fig. 18).
Connect feed cord to drill plug and
turn lock bush until the “click” (Fig. 17e).
Follow the same route to connect
battery pack (Fig. 17f).
➦
➦
FIG. 17d
FIG. 17f
FIG. 18
➟
➟
FIG. 17e
TDB 3 end piece
for enlarging existing holes
on rails inherent in the application
of electrical connections and for
additional special applications.
TDB 1 end piece for switch blades
and composite frogs
TDB 6 end piece for rails and stock rails
Seats to be used for
special applications.
FIG.13 – ASSEMBLY END PIECES
positioning pawl
pointing downwards
➟
➟
holding
plate
8.1) Assembling end pieces.
TDB 1, TDB 6 and TDB 3 end pieces of the DBG-F device, with moving arm, have been
designed for adaptation to the different operating conditions on rails and fittings;
their assembly is shown in Fig. 13.
•
When assembling the TDB 3 end piece ensure that the positioning pawl is pointing
downward in relation to the bolt.
• When disassembling the TDB 6 end piece ensure that, after removing the pivot, the
complete assembly is slid away downwards without acting on the holding plate.
•
Over-advancing the spindle after drilling must be avoided when using the TDB 1 and
TDB 3 end pieces.
17
22
90