Specifications

19. MANUTENZIONE
Before servicing or maintenance, stop the motor and disconnect the plug from
the battery pack.
After first 10 operating hours, proceed with sump oil change, as follows:
(Ref. to Fig. 31)
– Remove the cap with the magnetic insert (24).
– Remove the oil filler cap (06).
– Make sure that all the oil comes out by slightly tilting the drilling machine in order to
make the operation easier.
– Clean the cap (28) (see
§ 13.1.2 ).
– Reassemble the cap.
– Fill the oil sump to the level indicator (see
§ 13.1.1 ) using the oil supplied with the
drilling machine; it will be necessary to use about
140 ml oil.
– Replace the oil filler cap (06).
13.1) ORDINARY MAINTENANCE OF THE DRILL (Refer to Figs. 29 and 31)
Every 20 hours of operation
13.1.1) Topping up oil
With the drill switched off and placed on a flat surface, check the oil level in the crankcase
by looking through the appropriate transparent inspection cover (20).
The level must be approximately half way up the cover; if the level is low, top up the oil by
unscrewing the cover (06) at the top of the crankcase and adding the quantity of oil required.
Only use the oil grade recommended in § 1.
Never use regenerated or used oil.
The oil must be clean.
13.1.2) Removing metallic residue from the crankcase
13. MAINTENANCE
▲
!
When the drill is positioned as shown in
Fig. 29 unscrew the appropriate cap
with magnetic insert (24) on which any
metallic residue will have collected.
Carefully clean the magnetic insert with
a clean rag and screw it back in the
appropriate housing.
24
7
32
FIG. 29 –
REMOVING METALLIC RESIDUE
Broach cutter Guide bit
3.8) Broach cutters
Broach cutters resharpening must be carried out in compliance with appropriate modes of operationwhich allow
the best result. Contact
Cembre for assistance and for other specific broach cutters.
Note: Contact Cembre for other specific broach cutters.
BROACH CUTTERS FOR RAILS IN STEEL QUALITY 700-900-1100 (UIC 860.0)
A 135
A 140
A 150
A 160
A 170
A 180
A 190
Ø
mm
13,5
14
15
16
17
18
19
A 160L
A 170L
A 180L
A 190L
MAX DRILLING THICKNESS
25 mm
LONG RANGE (L max = 88mm)
Broach cutter
Guide bit
SHORT RANGE
Ref. PPL 1
Ref. PPL 2
Ref. PP 1
Ref. PP 2
MAX DRILLING THICKNESS
50 mm
3.7) VAL MPA tool case suitable for storing the
accessories indicated in 3.5 - 3.6, and the drilling tools.