Specifications

31
8
7
7,1
8
8,5
9
9,5
10
11
12
13
13,5
FIG. 1
SPECIAL SPIRAL BITS FOR RAILS IN STEEL QUALITY 700 - 900 - 1100 (UIC 860.0)
The drilling tools indicated in the tables guarantee optimum results. For tools of other types,
check the dimensional compatibility (particularly the size of the attachment and the length).
3.10) LR 2 BIODEGRADABLE LUBROCOOLANT
3 litre container to be used in a 5-10 % solution, for optimum operation of
both broach cutters and spiral bits.
3.11) LR 3 ANTIFREEZE CONCENTRATE
3 litre added to the lubrocoolant mixture in the right concentration will
maintain the lubrocoolant mixture fluid in negative temperature conditions.
– The special spiral bits in the PE range allow
automatic cooling by means of the
SR 5000 unit
supplied with the drilling machine.
– All spiral bits in the
PE range allow drilling of
thicknesses up to 45 mm.
L max
ø
APED...
APE...
ø
L max
h
3.9) Spiral bits
PE 140
PE 160
PE 170AR
PE 175
PE 180
PE 190AR
Ø
mm
14
16
17
17,5
18
19
Adaptor
type
Figure
h
mm
L
max
mm
APED 135/165
Spiral Bit
type
(*)
PE 70
PE 71
PE 80
PE 85
PE 90
PE 95
PE 100
PE 110
PE 120
PE 130AR
PE 135AR
Ø
mm
Adaptor
type
h
mm
L
max
mm
APE 90
APE 95
APE 100
APE 110
APE 120
APED 130
Figure
1
1
1a
(*) PE... AR: special high quality spiral bit.
Spiral Bit
type
(*)
1,6
76
76 1,6APED 70
1,2
88
85
APE 80
APED 135/165
3l
Drill
VAL LD
When the work has been completed, storage the drill by proceeding as follows:
12.1) Depressurise the tank of the SR 5000 cooling unit (see § 5), close the tap (02) on the
hose from the tank, and disconnect the quick-coupling (03).
12.2) Carefully clean the drill, particularly in the spindle area, removing machining waste
(swarf, etc.) and any deposits of lubricating coolant.
12.3) Fully withdraw the spindle.
12.4) Place the drill and the SR 5000 cooling unit in a sealed place free from dust, moisture
and the risk of accidental impact.
For better protection
Cembre recommends the use of the VAL LD metal case designed
for this purpose, which enables the drill to be located and locked in the case by means of
the clamping device.
12. STORING THE DRILL
FIG. 28
STORAGE CASE
FIG. 1a