#95798 (appearance may vary slightly)
READ THE SAFETY PRACTICES INSTALLATION AND MAINTENANCE INSTRUCTIONS AND YOUR WET/DRY VACUUM’S OWNER’S MANUAL BEFORE ASSEMBLING AND USING THE DUST DEPUTY 1. Do not vacuum anything that is burning or smoking, such as cigarettes, matches, hot ashes, or any hot substance! 2.
Part Number Part Description 95798 Quick Click Separator Qty 1 09768 BHCS 5/16” - 18Z 09801 Base Gasket 1 5/16 Allen Wrench 1 09790 Flange Nut 5/16 4 4 Please unpack the parts carefully and confirm you have received each item listed here. You will need the following: • Air tight dust container and lid • Power Drill • 3/8” Drill bit • Key hole saw • Wet/Dry Vacuum • Vacuum Hose • Vacuum hose adapters Dimensions subject to slight variations in manufacturing.
1 Draw 4.25” diameter circle on your supplied lid. Carefully cut out 4.25” hole in lid. Use 5/16” drill bit to drill bolt holes. Note: Use the Gasket for reference. 2 Turn Cyclone upside-down. Place Gasket on the base of the Cyclone and align all the holes. Place the topside of the supplied lid against Gasket and align all the holes. Secure Cyclone, Gasket and lid together using four Bolts, and four Flange Nuts. Note: Thoroughly tighten hardware to eliminate air leaks.
Attach in Series Increases particle efficiency and helps in very fine dust situations. Attach in Parallel Same particle efficiency but increases the CFM.
Part Number Part Description 09485 37L Stainless Recovery Bin (10 Gallon) 09856 77L Stainless Recovery Bin (20 Gallon) 68756 2.5” to 1.5” Vacuum Adaptor 34707 1.5” to 1.25” Hose End 95798 Quick Click Separator 41213 2.63” to 1.25” Vacuum Adaptor 12.6” 23” 09485 27.3” 5 16.5” 40.
Problem Cause Not separating well. Air leaks in the drum (Only a tiny amount of dust should reach the vacuums) Solution 1. Check for leaks between the lid and the dust drum. 2. Check for holes or leaks in the dust drum. 3. Check for leaks along the flange of the cyclone. Material swirls in cyclone and won’t drop into the dust container. Material swirls in cyclone and won’t drop into the dust container. Collecting large bulky material 1. Large, bulkier material might swirl.
Thank you for your purchase from our Quick Click series of dust collection accessories! Our intention is your complete satisfaction with this purchase decision. We welcome comments, questions, or suggestions on the items you have purchased related to their suitability in your application. You can email inquiries to customerservice@centecsystems.com or if preferred call us at 1-800-833-2822 during normal business hours 8:00 am to 5:00 pm CST Monday to Friday. Cen-Tec Systems Standard Warranty Provisions.
