OWNERS MANUAL READ BEFORE OPERATING YOUR SYSTEM
IMPORTANT SAFETY INSTRUCTIONS When using an electrical appliance, basic precautions should always be followed, including the following: • Read all instructions before using this appliance. WARNING: To reduce the rist of fire, electric shock or injury: • Always follow these safety instructions • Do not leave room when hose is plugged into the inlet. Disconnect power before servicing. • If equipped with an air turbine power brush unplug the vacuum hose before attaching power brush.
CAUTION: Do not use when rug (or floor) is wet. ATTENTION: Ne utiliser lorsque le tapis (ou le plancher) est moduille. SAVE THESE INSTRUCTIONS * THIS IS NOT A WET VAC * -WARNINGELECTRIC SHOCK COULD OCCUR IF USED ON WET SURFACES GROUNDING INSTRUCTIONS FOR CORD CONNECTED APPLIANCE This appliance must be grounded. if it should malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce the risk of electric shock.
PARTS Lid Latches For a secure fit of the lid. Utility Valve Hose plugs in here for vacuuming. HEPA-Style Bag Located inside, under the lid for easy, mess-free disposal. 5 ft Electric Cord Plugs into 110 outlet. Exhaust On/Off Switch Cannot be plumbed for use as a central vac.
INSTALLATION & MOUNTING CHOOSE THE MOUNTING LOCATION • • • • The unit must be mounted within 5 feet of an electrical outlet. Do not use an extenson cord. The unit should be mounted so that it is in a dry location and out of the way, but still accessible for emptying and accessing the utility valves. Suggested mounting: Minimum of 12 inches between unit lid and ceiling or shelving. Do not install this unit where ambient temperature regularly exceeds 120 degrees F. Vacuums must breathe... do not enclose.
FIRST TIME USE Before using your system for the first time, follow these steps. Protector plate must be installed properly for the vacuum to work. Make sure the PP101 Protector Plate is in place. This is necessary for proper suction. Upon receiving your vacuum system, lift off the lid. The protector plate should be located inside the can just below the HEPA bag. PP101 Protector Plate The protector plate is installed correctly when it lays flat, prong side down, directly under the HEPA bag.
USING YOUR SYSTEM Inserting the hose The hose connects to the system through the utility valve inlet on the side of the unit. On/Off Switch Insert the hose before turning the unit on. The system is turned on and off by flipping the switch on the side of the unit.
FIRST TIME USE This system uses a sealed HEPA type bag. The mass of dirt and debris is picked up by your vacuum and deposited into the bag inside your dirt canister. Emptying your dirt Can To remove accumilation, follow these steps: 1. Remove the lid by unhooking the clamps and releasing the latches on the top of the canister. (Fig. 1) Lift lid straight up. (Fig. 2) 2.
WARRANTY 5 YEAR LIMITED* WARRANTY Domestic Residential Use Only This warranty gives you specific legal rights, you may also have other rights which vary from State to State (or Province) ITEMS COVERED *The Aeon Vacuum system is warranted for a period of 5 years. Hoses, floor brushes and deaning tools are warranted for a period of 2 years. All warranties commence from the original date of purchase.
TROUBLESHOOTING Most problems that develop can be fixed easily by following the below suggested solutions: Vacuum cleaner won’t run Low suction or no suction • Be sure the unit is plugged in. • First, see above. • Be sure you turned the system on. • • Check your circuit breaker panel. Usually low suction is caused by a full bag. Change your bag. See operating instructions for details. • Make sure there is not too much on that circuit causing it to trip.
For replacement bags or to order additional tools or accessories, visit us at www.centecsystems.com or give us a call at 1-800-833-2822 1807 Morrissey Drive Bloomington, IL 61704 Phone: 309-664-0328 Toll Free: 1-800-833-2822 www.centecsystems.
