Installation manual

10
Fuse Inputs
The Fuse Input wires are
solid color wires and are color
coded to the Fuse Output wires.
The 3 Fuse input wires are:
 PINK- ”FUSE 1-3 INPUT”
 ORANGE- “FUSE 4-6 INPUT”
 RED- “FUSE 7-10 INPUT”
The power source these Input
wires are connected to will
determine if the Fuse Outputs will
be switched 12v or battery constant.
The splicing to connect each Fuse
Input to the Fuse Block, seen to the
left, comes pre-installed.
The illustration below shows how to create switched 12 volt power. The drawing
shows all wires associated with Fuses 7-10. Fuses 1-3 and/or Fuses 4-6 could also be
used in this manner if more or less switched 12 volt sources are required with your
application. The illustration also does not show the use of the junction block, refer to the
CIRCUIT BREAKERS and JUNCTION BLOCK drawing on page 16. The “BATTERY
B+ TO IGNITION SWITCH” wire seen in the illustration has been provided with the
Painless kit.