Installation manual

Painless Performance Limited Warranty

and Return Policy

Chassis harnesses, fuel injection harnesses and Striker ColdShot are covered under a

lifetime warranty. All other products manufactured and/or sold by Painless Performance

are warranted to the original purchaser to be free from defects in material and

workmanship under normal use. Painless Performance will repair or replace defective

products without charge during the first 12 months from the purchase date. No

products will be considered for warranty without a copy of the purchase receipt

showing the sellers name, address, and date of purchase. You must return the product

to the dealer you purchased it from to initiate warranty procedures.

FUSE BLOCK TEMPLATE

If for some reason you do not want to use the mounting bracket included with the

kit, above is a template of the main fuse block. The template can be used in a through

panel mount situation, such as a firewall .Some distortion to the template image may

take place due to the mass printing of this manual; these distortions will be less than

1/16” of an inch. Slight trimming may be needed once all holes, indicated by the

shaded areas, have been cut because of this distortion. To avoid possible trimming,

screw hole sizes could be enlarged to ¼” and cuts could be made 1/16” outside of the

shaded area.