Installation manual

5
INTRODUCTION
The Extreme Off-Road Harness can be used to wire any non-street legal vehicle.
Its 10 circuits and 4 relays will provide power to all critical and accessory components
associated with your vehicle. Unlike other chassis harnesses provided by Painless, this
harness only contains power Inputs and Outputs to and from the fuse block. With this
harness fitting such a wide range of vehicles, these instructions will be general
installation procedures. Referring to a factory wiring schematic of your vehicle will aid in
connecting factory charging and ignition systems and/or connecting to factory switches.
For aftermarket components, following the manufacturer’s instructions will be helpful in
connecting the Painless harness to their specific product.
CONTENTS OF THE PAINLESS WIRE HARNESS KIT
Refer to the Contents Figure (below) to take inventory. See that you have
everything you’re intended to have in this kit. If you find that anything is missing or
damaged, please contact the dealer where you obtained the kit or Painless
Performance at [phone].
The Painless Wire Harness Kit should contain the following:
 Wire Harness, with Fuse Block and relays installed
 1 small parts bag containing Maxi Fuse components and terminals
 1 large parts bag containing heat shrink, a junction block, 3 circuit
breakers, zip ties, relays, and a fuse label
 1 parts box containing miscellaneous ring terminals, terminals, fuses,
screws, nuts and washers.
 2 rolled wires (1 charge wire, 1 ignition switch wire)
CONTENT FIGURE- All of the parts in the Painless kit