Installation manual

7
contact with water or in a position which could be submerged in water during operation
of the vehicle.
Begin by installing the Fuse Block onto the Mounting bracket. The Fuse Block will
slide into the bracket causing the legs to “wrap” around the Fuse block. Refer to the
photo below and on the next page.
Using the 4 Philips head screws, mount the fuse block to the mounting bracket.
The Fuse Block cover can be mounted to the bracket by utilizing one of the Fuse Block
Mounting Holes. Some my find it easier to cut the tab from the fuse block cover
altogether to allow more room when the cover is removed.
Note: Applying a small amount of a silicone based lubricant on the red seal of the Fuse
Block will aid in getting the cover off at a later time after installation.
If you do not wish to use the mounting bracket, and would like to do a through
panel fuse block installation, a template has been provided for you on page 20.