Installation manual

8
Using 2 of the ½” self tapping screws and the holes pre-drilled at the top of the
Fuse Block mounting bracket secure the bracket to the vehicle.
MAXI FUSE
CAUTION: DISCONNECT THE POWER FROM YOUR VEHICLE BY REMOVING
THE NEGATIVE OR POSITIVE BATTERY CABLE FROM THE BATTERY. THE
BATTERY IS NOT TO BE CONNECTED UNTILL THE PAINLESS HARNESS HAS
BEEN INSTALLED AND TESTED.
Begin by locating the MAXI FUSE component bag in the parts kit. These
components are: a MAXI FUSE Base & Cover, a self-tapping mounting screw, the 100
AMP MAXI FUSE, and several different size ring terminals.
 Using the mounting screw, mount the fuse base as close to the battery, or
battery power source, as possible. This power source can be the Battery
itself or the B+ at the Starter Solenoid.
 Actual connections made to the Maxi Fuse will differ according to your
specific application requirements; refer to the CIRCUIT BREAKERS AND
JUNCTION BLOCK illustration, page 16, for the proper connection of the
Maxi Fuse.
 Install the MAXI FUSE into the BASE, and the COVER over the MAXI
FUSE assembly. Before doing so, make certain that the Positive or
Negative Battery Cable is not connected. Harness failure will result.