Installation Guide

21
INSIDE CORNER ROLLER INSTALLATION INSTRUCTIONS
BOLT
WASHER
WASHER
ROLLER
NUT
Step One:
Place bracket on desired corner post, making sure it is in
line with the rail that will be installed. Use the bracket as a
template to mark holes before drilling as shown in
Illustration A.
Step Two:
Drill two 7/16” holes THRU the post. Remove the plastic
roller and washers from the bracket and mount it to the
post using the supplied carriage bolts, washers, and nuts
as shown in Illustration B. Repeat this step for addi-
tional installations.
NOTE: If bolts are sticking out on back side of
post, cut off to prevent injury.
Step Three:
Run fence rail through corner roller bracket as show in
Illustration C.
Step Four:
Attach plastic roller and washers to bracket as shown in
Illustration D and tension rail as needed.
A
B
C
D
INSIDE CORNER ROLLER INSTALLATION INSTRUCTIONS