Operating instructions

Page 18For technical questions, please call 1-800-444-3353.SKU 98194
REV 09j
side of the Blade slightly clears the edge


Ensure that the left side of the Blade
clears the Kerf Board. Tighten the four
screws holding the Kerf Board in place.
Cleaning and Lubricating the Miter
Saw
Observe the Dust Bag while using 1.
the saw. Empty the sawdust into an
appropriate container when the bag is
full.
Occasionally wipe or blow off sawdust 2.
that accumulates on the saw. Saw dust
on the Fence can cause you to make
inaccurate cuts.
Keep the Slides free of sawdust. Wipe 3.
or blow them off as required. Use a dry
lubricant or wax on the slides. Do not
use an oil or grease lubricant, as this will
attract dust.
Occasionally lubricate the pivot point of 4.
the Table as well as other moving parts
with a dry lubricant, such as graphite.