User guide

ManualsBrandsCenter ManualsConsumer electronicsEHE0200154

User Guide

for EHE0200153 & EHE0200154

Programmable Room Thermostat

The EHE0200153 & EHE0200154 are programmable room thermostats designed to

control your heating system efﬁciently, providing comfortable temperatures when you are

at home and energy savings when you are away. The following instructions explain how

to program and use the thermostat to provide the most home comfort at the least cost.

Description

OFFMANAUTO

Mon T u e We d Thu Fri Sat Sun

OFFMANAUTO

•

Ergonomic user interface featuring an ‘OK-button’.

• LargeLCD(LiquidCrystalDisplay)Screen.

• 4independenttemperaturelevels(from5°Cto

35°C).

•

Built-in Memory holds the user program indeﬁnitely.

Features of the EHE0200153

•

Ergonomic user interface featuring an ‘OK-button’.

• LargeLCD(LiquidCrystalDisplay)Screen.

• 7-dayheatingprogramtomatchyourlifestyle,

whilst maximising energy savings.

• 4independenttemperaturelevelsperday(from

5°Cto35°C).

•

Built-in Memory holds the user program indeﬁnitely.

Features of the EHE0200154

EHE0200153 User Guide .............. page 2-6

EHE0200154 User Guide ............ page 7-12

42010941-015 AA

Summary of content (12 pages)

PAGE 1
User Guide for EHE0200153 & EHE0200154 Programmable Room Thermostat Description The EHE0200153 & EHE0200154 are programmable room thermostats designed to control your heating system efficiently, providing comfortable temperatures when you are at home and energy savings when you are away. The following instructions explain how to program and use the thermostat to provide the most home comfort at the least cost. Features of the EHE0200153 • Ergonomic user interface featuring an ‘OK-button’.
PAGE 2
EHE0200153 User Guide Controls Layout 1 2 3 4 5 6 7 AUTO 13 AUTO MAN 12 OFF PROGRAM 8 1..
PAGE 3
Setting-up the EHE0200153 This section shows you how to setup and run the thermostat in 3 simple steps: STEP 1: Installing the Batteries Note: Please follow the instructions in this section only if the thermostat screen is blank (no symbols or digits are displayed). If the room temperature is already displayed move on to Step 2: Setting the Time. To install the Batteries: a. Lift up the front cover of the thermostat to reveal the battery cover and product controls. b.
PAGE 4
Programming the EHE0200153 The Built-in Heating Program The built-in heating program has 4 temperature level changes that can be set between 3.00am and 2.50am the following day - allowing you to maintain the evening temperature after midnight. Each temperature level can be set between 5°C and 35°C, and adjusted in 0.5°C increments. The factory default program for heating is as follows.
PAGE 5
To disable or enable time periods: a. To disable unwanted periods go to the desired period ( 2 to 4 ) using the PROGRAM or buttons to navigate, ensure the correct period is highlighted with the flashing square symbol. Press and hold the button for at least 2 seconds and the display will indicate the period has been removed from the program. b. To enable periods again follow the same procedure as above, navigating to the already disabled period.
PAGE 6
Troubleshooting the EHE0200153 Symptom Remedy Blank Display (Power Loss). Check batteries are installed by removing the battery cover. Check batteries have been installed in the correct orientation. Replace the batteries. Display shows flashing symbol. Display shows symbol. The batteries in the thermostat are low on power - Replace the batteries. A fault has occurred in your heating system. Remove and re-insert the batteries. symbol does not clear after a few If the minutes contact your installer.
PAGE 7
EHE0200154 User Guide Controls Layout 1 16 2 14 4 5 6 7 Mon 15 3 Tue Wed Thu DAY Fri Sat Sun 8 AUTO COPY DAY AUTO MAN 13 OFF PROGRAM 9 1..
PAGE 8
Setting-up the EHE0200154 This section shows you how to setup and run the thermostat in 3 simple steps: STEP 1: Installing the Batteries Note: Please follow the instructions in this section only if the thermostat screen is blank (no symbols or digits are displayed). If the room temperature is already displayed move on to Step 2: Setting the Date and Time. To install the Batteries: a. Lift up the front cover of the thermostat to reveal the battery cover and product controls. b.
PAGE 9
Programming the EHE0200154 The Built-in Heating Program The built-in heating program has 4 temperature level changes per day that can be set between 3.00am and 2.50am the following day - allowing you to maintain the evening temperature after midnight. Each temperature level can be set between 5°C and 35°C, and adjusted in 0.5°C increments. The factory default program for heating is as follows.
PAGE 10
Programming the EHE0200154 d. The temperature setting for period 1 on Monday (Day 1) will now be flashing. To adjust this press the button. or buttons and confirm the setting again by pressing the e. The next time and temperature period will now be active. Adjust this by repeating steps b - d above until all 4 periods are set for Monday or press the AUTO button to run the program as set, at any time. You now have a choice of how to set the program for the next day: f.
PAGE 11
Operating the EHE0200154 Choosing the Operating Mode The thermostat can operate in three different modes: Automatic, Manual or Off. To set the operating mode press either of the AUTO, MAN or OFF buttons. The screen indicates which mode is currently active by displaying AUTO, MAN or OFF. • AUTO (automatic) mode sets the thermostat to follow the built-in temperature program (default or personalised).
PAGE 12
Troubleshooting the EHE0200154 Symptom Remedy Blank Display (Power Loss). Check batteries are installed by removing the battery cover. Check batteries have been installed in the correct orientation. Replace the batteries. Display shows flashing symbol. Display shows symbol. The batteries in the thermostat are low on power - Replace the batteries. A fault has occurred in your heating system. Remove and re-insert the batteries. symbol does not clear after a few If the minutes contact your installer.