User guide

10
Programming the EHE0200154
d. The temperature setting for period
1
onMonday(Day1)willnowbeashing.To
adjust this press the or buttons and confirm the setting again by pressing the
button.
e. The next time and temperature period will now be active. Adjust this by repeating
steps b - d above until all 4 periods are set for Monday or press the AUTO button to
run the program as set, at any time.
You now have a choice of how to set the program for the next day:
f. i) Press the COPY DAY button to copy Monday’s program into Tuesday. The display
willgoblankapartfromthe‘nonashing’dayindicator,whichindicatestheday
copied and the ‘flashing’ target day to copy the program to. To accept this day
press the button. To select a different target day press the DAY button until the
‘ashing’dayindicatorisundertherequiredday,thenacceptitbypressingthe
button. Note: Once the target day is confirmed it becomes the day that is copied if
the COPY DAY button is pressed again.
OR
ii) Press the DAYbuttontomovethedayindicatortoTuesday(Day2).Theprogram
for that day can then be adjusted by following steps b to e. Programs for the
remaining days can be set in the same way, using the DAY button to move to the
next day.
To exit the programming mode select the desired operating mode by pressing the
AUTO, MAN or OFF buttons. Note: To run the adjusted program select the AUTO
mode.
Disabling / Enabling Time Periods
The thermostat has 4 periods each day that can be programmed, but you may not
needalloftheseswitchpointsforyourheatingrequirements.Therefore,anyperiod
from2to4canberemovedfrom(orreturnedto)theheatingprogramprole.
To disable or enable time periods:
a.Todisableunwantedperiodsgotothedesiredperiod(
2
to
4
)usingthe
PROGRAM or buttons to navigate, ensure the correct period is highlighted
withtheashingsquaresymbol.Pressandholdthe button for at least 2 seconds
and the display will indicate the period has been removed from the program.
b. To enable periods again follow the same procedure as above, navigating to the
already disabled period. To enable this period again press and hold the
button for
at least 2 seconds.