User guide

8
This section shows you how to setup and run the thermostat in 3 simple steps:
STEP 1: Installing the Batteries
Note: Please follow the instructions in this section only if the thermostat screen is
blank (no symbols or digits are displayed). If the room temperature is already displayed
move on to Step 2: Setting the Date and Time.
To install the Batteries:
a.Liftupthefrontcoverofthethermostattorevealthebatterycoverandproduct
controls.
b. Remove the battery cover by pressing down and sliding out.
c.Insertthe2xAALR6AlkalineBatteriessuppliedwiththethermostat,ensuringthe
correctorientation(see‘Controls Layout’onpage2).
d. After a short pause the thermostat will display information on the screen and is now
ready for use.
e.Replacethebatterycoverbyslidingitrmlybackintothefrontofthethermostat.
STEP 2: Setting the Time
To set the Date and Time:
a.
Press the DAY button once and the ‘day indicator’ will begin to flash.
b. Press the DAYbuttonuntilthecorrectdayisreached(Day1=Monday).Pressthe
button to confirm.
d. Press either of the
or buttonsoncetoentertimesettingmode.TheLCD
screenashesthetimedigits(whentheunitispoweredforthersttimethedisplay
shows12:00).
e. Use the
or buttons to set the correct time then press the button to
confirm. Each press of the buttons will change the time by one minute and holding
themdownwillchangethetimeslowlyatrstandgetprogressivelyquicker.
Note: If this mode is entered accidentally then press the AUTO, MAN or OFF
buttons to exit.
STEP 3: Running the Built-in Heating Program
The thermostat is now ready for operation. Press the AUTO button and the built-in
heating program will start running.
Note: The built-in heating program has been designed to provide normal comfort
requirements, but if you want to customise the settings please see the next section
‘Programming the EHE0200154’.
Setting-up the EHE0200154