Installation Sheet

ManualsBrandsCentral Brass ManualsBar Faucets2-Handle Bar Faucet in Chrome

Installation Guide

Two Handle Shell Type Bar/Laundry Faucet:

0094 Series •

This product meets the following standards:

ASME A112.18.1 •

ANSI A117.1 •

CUPC / IAPMO LISTED / ADA COMPLIANT•

CONTAINS NO MORE THAN 0.25% WEIGHTED AVERAGE •

LEAD CONTENT

C O M P A N Y

A Division of Pioneer Industries, Inc.

Central Brass

REV-11 10, 11

Summary of content (6 pages)

PAGE 1
Central Brass C O M P A N Y A Division of Pioneer Industries, Inc. Installation Guide Two Handle Shell Type Bar/Laundry Faucet: • 0094 Series This product meets the following standards: • ASME A112.18.1 • ANSI A117.1 • CUPC / IAPMO LISTED / ADA COMPLIANT • CONTAINS NO MORE THAN 0.
PAGE 2
Thank You For Choosing Central Brass Products Thank you for purchasing this quality product. Central Brass products are rigorously tested to provide long service under normal conditions. Prior to installation, familiarize yourself with this products diagram. Make sure that you have all of the illustrated parts for your Central Brass product before installation. Care Instructions Central Brass products are designed and engineered under strict quality standards.
PAGE 3
CENTRAL BRASS LIMITED WARRANTY The Central Brass Company provides to the original consumer the following warranties for Genuine Central Brass manufactured products and components used in commercial or residential applications. Central Brass Company will replace, free of charge, to the original consumer purchaser, any and all parts that prove defective under normal installation, use, and service.
PAGE 4
Faucet Installation 1. If the handles (A) are not installed on the body, Install the handle (A) to the faucet body (C). Install spout (B) to the faucet body (C). If you are installing rigid spout then use adjustable wrench to install the spout (B). 2. Apply plumbers putty under neath of the cover plate gasket. Ensure to place cover plate gasked underneath of the faucet body. Place the faucet through the mounint surface. 3. Slide the crowfoot washer (D) through shank from underneath of the mounting surface.
PAGE 5
Main Supply Connection 4. Connect the faucet shank to inlet supply lines (F). 5. Connect the supply stops (G) to the inlet supply lines (F) (left is hot water supply and right is cold water supply). Make sure inlet supply lines (F) are securely tighten. Do not overtighten. Turn on water. Check for any leaks. Make sure all the connections are secure. 6. Remove aerator (H).Open the handles.Flush and allow water to run at full flow for at least one minute. Close the handles. 7. Replace aerator (H).
PAGE 6
Central Brass C O M P A N Y A Division of Pioneer Industries, Inc. 6892 Snowville Road | Brecksville, Ohio 44141 Telephone: (800) 321-8630 | (216) 883-0220 | Fax: (800) 338-9414 Hours: M - F, 7:30am to 5:00pm EST www.centralbrass.