User's Manual

CHAIN BRACKET
HOOK (17)
FIGURE C
SADDLE
ASSEMBLY
(12)
WING NUT (20)
(NOT SHOWN)
9. Once you are sure the transmission is secured by the Chain (13), remove the
bolts and other hardware holding the transmission to the chassis.
10. Make sure the area is clear of people and tools, and verify that the transmission
is securely held in place by the Transmission Jack. Then, slowly turn the Release
Valve (47) counterclockwise to lower the Transmission Jack to its lowest position
before moving the unit. (See Figure A.)
11. Carefully wheel the Transmission Jack from under the vehicle to perform the
desired maintenance on the transmission.
To Raise The Transmission Back Into Place:
1. After performing the maintenance on the transmission, move the Transmission
Jack under the vehicle so that the transmission is lined up properly with its
connection points.
2. To raise the transmission, turn the Release Valve (47) clockwise to its closed
position. Pump the Handle, using full, smooth strokes. (See Figure A.)
3. Guide the transmission into place, and replace the bolts and other hardware to
secure the transmission to the chassis. Double check to make sure the transmis-
sion is securely installed.
SKU 91020 PAGE 8
CONNECT
CHAIN
HERE.
CONNECT CHAIN
TO